Construction Regulations For Wall Panel Metal Siding
2021年10月29日
Construction Regulations For Wall Panel (Metal Siding)
-
- In order to make the wall panel(metal siding) to meet our later use requirements, in the construction process, we need to follow a certain construction law and methods, because only to meet certain requirements, construction can be more smooth, the project can also be completed more perfect. Below for you to introduce specifically what construction regulations:
- 1. The temperature of the inner surface of the insulation layer is higher than zero degrees, wherein the door and window frame outside the hole around the hole, daughter wall, closed balcony and pick out components and other hot bridge parts should take insulation measures, the above parts should be reserved for the thickness of the metal siding.
- 2. The external insulation system should consider the metal anchor firmware, the thermal bridge under the influence.
- 3. The exterior wall insulation project should do a good job of sealing and waterproofing structure design, to ensure that water will not seep into the insulation layer and the grass-roots level, important parts should have detailed maps.
- 4. Horizontal or tilted pick-out areas and extended to the ground below the site should do a good job of waterproof treatment, in the external wall insulation system installed equipment or pipes should be fixed on the grass, and should do a good job of sealing and waterproofing design.
- 5. The use height of the exterior wall insulation system should comply with the following provisions: the use of sticky anchor (or adhesive hanging) process installation and paint finish, its use height should not exceed 60m, the actual height of use should be insulation decorative panel exterior wall insulation system measured anti-wind pressure value design calculation. Insulation decorative package with thin type stone as the panel should be installed using the sticky anchor (or sticky hanging) process, the actual height should not be greater than 40m, and should be specially designed, its safety and durability must comply with the relevant regulations and design requirements.
- Everyone in the metal siding construction, we must abide by the above provisions, only in this way, can be our project completed at half-time, and the aesthetics are higher.
- Get In Touch: +86-18115459757
